Wurth Super RTV Silicone (08933313) Adhesive Gasket Maker Sealing Hi Temp (BLUE)

High-quality adhesive and sealing compound for use in industry and the automotive sector.
Excellent resistance to chemicals
Can also be used in critical areas in which the seal comes into contact with various liquids
Outstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agent
 
Non-acidic hardening system
Non-corrosive, therefore has no negative impact on electronic components and on lambda probes
 
Sealant in compressed-air can
Easy to dispense without additional aids
The fine beads allow the product to be applied uniformly
Notice
When sealing e.g. oil pans and gearboxes it is vital that no sealant gets into the interior. For this reason we recommend to apply the sealant on a joining part surface. Join both parts and then carefully press by hand and lightly slide against each other. Afterwards separate the parts again and then remove the sealant that has gone inside. Join the components again within a max. of 5 minutes and tighten firmly. Before commissioning, observe the hardening time (depending on the sealant thickness).
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Colour
Blue
Contents
200 ml
Chemical basis
Neutral crosslinked silicones, oxime-based
Smell/fragrance
Characteristic
Min./max. temperature resistance
-60 to 260 °C
Max. short-term temperature resistance
300 °C
Range of applications
Oil pans
Valve cover
Rear axle housing
Crankshaft housing
Differential housing
Camshaft bearing cover
Density
1.25 g/cm³
Min. skin-formation time
5 min
Conditions for skin-formation time
at 23°C and 50% relative humidity
Full curing speed
3 mm/d
Fully hardening/curing conditions
23°C and 50% relative humidity
Shore A hardness
24
Min. tensile strength
2.2 N/mm²
Conditions for tensile strength
in accordance with ASTM D-412
Max. breaking elongation/conditions
500 % / in accordance with DIN 53504
Heat conductance λ
0.2 J/(m*s*K)
Heat conductance λ conditions
in accordance with ASTM D-2214/70
Coefficient of thermal expansion
0.0002 1/K
Coefficient of thermal expansion conditions
in accordance with ASTM EB-31
Dielectric strength
16 kV/mm
Dielectric strength conditions
in accordance with ASTM D-149
Relative permittivity
2.8
Conditions for relative permittivity
1 MHz, ASTM D-150
Loss factor
0.002
Loss factor conditions
1 MHz, ASTM D-150
Specific volume resistivity
1000000000000000 Ohm/cm
Conditions for specific volume resistivity
in accordance with ASTM D-257